Stc-600 Temperature Controller Manual Pdf Info

Understanding the electrical and physical limits of the STC-600 ensures safe installation and optimal performance.

A clear understanding of a device's specifications is crucial before installation. Based on information sourced from product listings and manuals, here are the primary technical parameters for the STC-600.

The measured temperature exceeds the physical limit of +70°C.

The compressor will turn off when the room cools down to . 🚨 Troubleshooting and Error Codes Stc-600 Temperature Controller Manual Pdf

The STC-600 is a dual-stage temperature controller. This means it can control both a heating and a cooling device simultaneously (or just one or the other). While the hardware is robust, the programming logic relies on specific acronyms (like F1, P1, Hy, and CP) that are not immediately intuitive.

Slide the plastic mounting clips from the back until the unit is secure. 2. Wiring Connections Power supply input (220VAC). Terminals 3 & 4: NTC Temperature sensor probe connection.

| Code | Parameter Name | Default Setting | Recommended Range | | :--- | :--- | :--- | :--- | | | Temperature Set Point (SV) | 25°C | Your target temp | | F2 | Differential / Hysteresis (HY) | 2.0°C | 0.5°C - 5.0°C | | F3 | Cooling Delay Protection (PT) | 3 Minutes | 0-10 min (3 min saves compressor) | | F4 | Temperature Calibration (CA) | 0.0°C | ±5°C | | F5 | Unit Selection (CF) | 0 = Celsius | 1 = Fahrenheit | | F6 | High Temperature Alarm (AH) | 99°C | Set above your max desired temp | | F7 | Low Temperature Alarm (AL) | -40°C | Set below your min desired temp | Understanding the electrical and physical limits of the

The STC-600 temperature controller is used for precise temperature control in various industries, including food processing, pharmaceuticals, and HVAC.

| Code | Function | Default | Range | Description | |------|----------|---------|-------|-------------| | F1 | Heating differential | 2.0°C | 0.1–15°C | Heating stops when PV ≥ SV | | F2 | Cooling differential | 2.0°C | 0.1–15°C | Cooling starts when PV ≥ SV+F2 | | F3 | Temperature calibration | 0.0°C | -10–10°C | Adjust sensor deviation | | F4 | Compressor delay | 0 min | 0–10 min | Anti-short cycle delay | | F5 | High temp alarm | 110°C | Off, SV–120°C | Alarm if PV > F5 | | F6 | Low temp alarm | -50°C | -50–SV | Alarm if PV < F6 | | F7 | Working mode | 0 | 0 or 1 | 0=Cooling priority, 1=Heating priority | | F8 | Restore defaults | 0 | 0 or 1 | Set to 1 to reset all settings | | F9 | Temperature unit | 0 | 0 or 1 | 0=°C, 1=°F |

The STC-600 interface is designed for straightforward operation and programming. The measured temperature exceeds the physical limit of

Note: The STC-600 switches the live line through its internal relays. You must loop the live power from your power input into the relay common terminal to feed power to your compressor or heater. User Interface & Button Functions

: If the display shows "0000" or an error code, it typically indicates the input signal exceeds the range or the sensor circuit is open. Compressor Protection

for a specific appliance, such as a fermentation fridge or a commercial cooler? stc-600 instructions

The differential value prevents your compressor or heater from rapid cycling (turning on and off too frequently).